Microe PurePrecision Manual do Utilizador descarregar pdf (Página 15)

Page 15

Tape Scale, OPS Side Mount Configuration

Installation By Mounted Applicator Tool

Peel off a short section of bottom adhesive backing approximately 50mm (2 inches).

PurePrecision Tape Scales have 3 layers, blue protective film, steel scale, and adhesive backing.

Using a sharp tool or fingernail, initiate the peeling of the adhesive liner from the end of the tape scale that will

be inserted into the applicator tool entry channel.

Turn Applicator Tool to the “Up” position and insert tape into applicator tool.

Rotate the knob that controls the contact cylinder plunger to the UP position. This allows you to insert the first

section of adhesive exposed tape, into the applicator tool.

Be sure that both the tape scale orientation arrows and the applicator tool arrows point in the same direction.

Tape Scale

orientation arrows

Tool

orientation arrows

Plunger in UP

position

Close-up of plunger knob in the UP

position. The position of the keyways

indicates UP or Down. Rotating the knob

will both move the plunger up or down.

Adhesive backing

liner

NOTE:

Do not peel the blue

protective film off at

this time.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Sem comentários

Microe PurePrecision Manual do Utilizador Página 15